Synth.nl
is documenting his progress on the construction of a
Yusynth DIY modular. You might remember his similar posts on the ASM-2 and more
previously posted here. The posts are definitely worth checking out if you are curious about one person's experience in creating a DIY modular synth.
The following is a small excerpt from the
latest post: "I made quite some progress today. I almost finished the VCO and LFO modules now. I'm still missing 4 resistors and 4 trim potmeters, but I will get them next week. I did correct an error as well. I mounted two 10K resistors on a spot where 18K should have been. I found this out because I had two 18K resistors left ;) So I started looking where they were supposed to be. Always good to do these kind of cross checks in the end. In the picture on the left you see all the modules I have so far. Still a lot to go."
Synth.nl is documenting his progress on the construction of a Yusynth DIY modular. You might remember his similar posts on the ASM-2 and more previously posted here. The posts are definitely worth checking out if you are curious about one person's experience in creating a DIY modular synth.
The following is a small excerpt from the latest post: "I made quite some progress today. I almost finished the VCO and LFO modules now. I'm still missing 4 resistors and 4 trim potmeters, but I will get them next week. I did correct an error as well. I mounted two 10K resistors on a spot where 18K should have been. I found this out because I had two 18K resistors left ;) So I started looking where they were supposed to be. Always good to do these kind of cross checks in the end. In the picture on the left you see all the modules I have so far. Still a lot to go."
No comments:
Post a Comment
Note: To reduce spam, comments for posts older than 7 days are not displayed until approved (usually same day).