via nyd on electro-music.com
"These MFOS modules are squeezed in the 6U Eurorack.
10-step seq
2 x active splitters
2 x active CV mixers
S/H
Phaser
Noise cornucopia
12 db multimode VCF
24 db LP VCF
2 x dual VCA
4Ch Stereo mixer
Auto panner
16-step sequencer
Dual AR
VC LFO
2x ADSR Envelopes
2 x VCO
Sonic multiplyer
More pictures, and a sound example, can be found at my project page.
http://nydell.se/projects/modulator
I'll post more sound clips in the future."
DIY Modular playing Nitzer Ebb
YouTube via hnydell | July 18, 2010
"My DIY MFOS modular - the Modulator - playing Isn't it funny how your body works by Nitzer Ebb. The 16-step sequencer's gate outputs trigs two ADSRs for bass drum. Clock out is sent to slave 10-step sequencer and to two ARs controlling filter cutoff and VCA. 16 step seq CV out gets patched to both VCOs. The stereo auto panner is used during the last few seconds."
Roland System 100m vs MFOS - DIY modular VCF shootout
hnydell | June 15, 2010
"Comparison between Roland System 100m 121 VCF module and the Music From Outer Space 4-pole VCF.
Setup: MFOS 16 step sequencer driving two MFOS VCOs. Each VCF is fed a sawtooth and a pulse wave from the VCOs, slightly detuned. An MFOS AR envelope controls the VCA (Sys 100m 130), an MFOS ADSR controls the two filters. The sequencer is in 2x8 mode, where the second half later is patched in to the VCF control.
Since the 100m uses 15 volts, the MFOS adsr (12V) cannot really sweep through the full VCF frequency span on the 121. This is not very apparent though."
No comments:
Post a Comment
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).