via NOISEBUG Reverb
"The module format follows industry standard (synthesizers.com/Moog/Curetronic/Mos-Lab etc.)
Modules work with supply voltages of -12...-15 Volts/+12...+15 Volts
Two power connectors are on-board (synthesizers.com/Club of the Knobs),
Threshold voltage of the trigger inputs is +1 Volt.
The modules are ready to be used: insert the module, connect the power plug,
attach with a couple of screws and the fun starts...
The M565 v3 QUAD QUANTIZER features four independent quantizer circuits.
The module quantizes variable control voltages into semitone intervals (1/12 volt) over an input voltage range –10.58 to +10.58 volts, in other words more than 2 x 10 octaves (128+128 semitones).
Gate pulses fed into the "Gate In"-jack trigger the quantizer; in "low" state no quantization occurs (useful to sync the quantization process precisely to a sequencer-clock out).
An "open" gate input is recognized by the module, it quantizes, i. e. if no gate jacks are patched. The four gate-ins are passed through, one plugged IN 1 feeds IN 2 to IN 4 as well. The gate outputs supply a pulse, whenever the (quantized) output voltage changes. The LEDs display exactly this pulse. The most recent quantized value remains preserved until the next quantization will occur.
Two adapters are on-board to connect one or two M 565 D Quantizer Controller modules. The M 565 v3 does support the connection of M 565 E modules, too.
An M 565 v1 or M 565 v2 Quad Quantizer Module can be updated to v3, to allow connection to M 565 D controllers and the M 567 programmer module."
No comments:
Post a Comment
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).