The DSP Synthesizers Jano-Xk synthesizer based on the Roland Juno-106 DCO is now on Indiegogo. Click through for details.
"Integrator Jano-DCO with SAW, SuperSAW, SQR with PWM and SUB mix output.This is NOT a VA synth.
The oscillator is a digitally controlled analog oscillator based on the ATmega328.
The output from the DCO-integrator is 100% analog signal.
All 4 waveforms can be simultaneously mixed.
Triangle LFO for PWM and pitch modulation.
Portamento/glide for notes.
Arpeggiator with up-mode, rate and note lenght.
Gate output with oscillator set as gated, arpeggiated or hold mode and 5 volt CV output for highest note played on the keyboard or arpeggiated chords.
12dB HPF and +24dB LPF with resonance.
Outputs are monoaudio and 5 volts CV/Gate."
No comments:
Post a Comment
Note: To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).