AX60 & S612 Sample

Title link takes you there. Track title is the one with via nematode. via Jon:

"i just got an s612 in the mail yesterday (bought it off kevin, you posted one of his gear sales, so thanks) the 13 pin connectors came in at the same time. so i painstakingly soldered 26 tiny little leads, then i looked in the s612 manual and realized i only had to solder 14 tiny little leads. plugged my new cable in, ran a midi cable from the ax to the s612. messed around with midi channels and worked the static out of the ax's a/b mix slider, knocked over a full stack of 100 blank dvdrs in the process and within about an hour or so was up and running. there's an 8 minute (in two parts) 3 track overdub of just the ax-60 and the s612 arpegiating while i twist and tweak (the sample start/end time faders are awesome) up on my myspace page it's called nematode something-or-other. i was up 'till about 4.30 last night getting that posted, so now i'm going to get some donuts and, if the neighbor kids quiet down, take a nice long nap."

Update via a follow up email from Jon: "this too, i don't know if it's been pointed out yet, but as only audio is being sent to the ax60, there are no control signals envolved, the ax should be able to run -any- audio input through it's filter. all it should take is wiring the leads from an audio connector (your choice) to the ground and signal pin (again, your choice) of the input on the synth."