MATRIXSYNTH: Roland Juno 60 Van Halen Jump by JimmyPound


Wednesday, December 12, 2007

Roland Juno 60 Van Halen Jump by JimmyPound


YouTube via synthartist69.

"Here is a Video of the Juno 60 in action. I programmed the jump patch from an analog brass sound by changing the cutoff, resonance, Attack, and chorus. The secret to getting a good Van Halen OBXA patch lies within the boundaries of a good chorus delay or reverb effect. This version is not exactly right, but it works. I played the bridge two different ways throughout the song and both are an easy variation of the original. Same goes for the synth part under the guitar solo. Hope you enjoy!"
Posted by matrix at 12/12/2007 12:16:00 AM
LABELS/MORE: ,

2 comments:

  1. synthex5912/12/07, 2:34 PM

    Very efficient, thanks, very good
    I didn't guess it could be done with a Juno60.

    ReplyDelete
  2. Doktor Future12/12/07, 6:16 PM

    That's so unbelievable. I'd only really be 'into' this video if he played it while sitting on his motorcycle.

    ReplyDelete

Note: To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).

PREVIOUS PAGE NEXT PAGE HOME


Switched On Make Synthesizer Evolution Vintage Synthesizers Creating Sound Fundlementals of Synthesizer Programming Kraftwerk

© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
Subscribe to: Post Comments (Atom)