"This page describes the my Beta evaluation of a prototype MOTM-730 module.I received the prototype from Paul and set it on my ARP sequencer with a 6 pin power cable into my top cabinet. I am using a PowerOne HCAA-60W-A power supply with a MOTM-990 distribution board. The MOTM-730 had a lot more jacks than I was expecting with a total of 11 for the divider outputs and 3 for inputs. There are also 2 potentiometers, three switches, a jumper strap, and the 3 digit LED display."
via ModularSynthesis where you can find more info on the MOTM-730.
No comments:
Post a Comment
Note: To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).