via Bananalogue on this electro-music.com thread:"Hi folks! I've decided to offer a VERY limited number (15) of Bananalogue VCS PCB sets to the synth DIY community. The set is four boards, three for components and pcb mount hardware with a fourth optional bridge board (you could opt to use fly wires if you want to play with different panel designs). Please note the following caveats BEFORE ordering from me:
1. these are an early revision of the Bananalogue VCS and the PCBs don't have any spare room vertically to squeeze into a frac/euro rack. we redesigned after this revision to allow more room between the rack rails - so please consider that.
2. i will not be offering ANY support or documentation for these PCBs, we simply don't have the time, so not a good project for beginners!
3. the PCBs have all the component values and placement silkscreened on them. if you have successfully built one of Ken Stone's CGS boards you should be familiar with this system. if you have NOT built a CGS board i would STRONGLY discourage you from starting here.
so, if you are still bold enough - email me with your shipping address and i will send you my paypal account. sets are $40 each, and shipping should be about $3 USA, $6 overseas
and they are a very pretty red"
No comments:
Post a Comment
To reduce spam, comments for posts older than one week are not displayed until approved, usually same day. Do not insult people. For items for sale, do not ask if it is still available. Check the auction link and search for the item. Auctions are from various sellers and expire over time. Posts remain for the pics and historical purposes. This site is meant to be a daily snapshot of some of what was out there in the world of synths.