Sunday, September 06, 2009
Arduino-based clone of the CGS Master Divider
YouTube via machinate
"Okay, this is my little pet project; getting the Arduino to be the clocking centre of my modular synth.
The idea is to have this either as a computer-controlled divider run by your DAW (I plan to port this software fully into MaxForLive when that drops) OR as a standalone unit with set/reset jacks right on the panel.
For the really nerdy nerds out there: I may even do this as an Arduino-Mega setup with the odd subdivisions as well as standard 1-16 sequencing outs... If I do I'll probably do a few panels and sell a couple, if there's interest.
This is just my little proof of concept, but I hope you enjoy!"
PREVIOUS PAGE
NEXT PAGE
HOME
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).