Full details on Derek Revell's website. PCBs are now available if you'd like to make your own EMS Synthi A or VCS3 clone.
The bottom image here is the clone.
"I have made the clone , using the dimensions of the original VCS3 they are H 44cm x W 43cm x D 42cm.
The panels sizes are upper W 40cm x H 32cm x 2mm and the lower panel is W 40cm H 30cm x 2mm.
The VCS3 clone is complete on 16/03/2010, but needs fully calibrating, as there are some differences with the pots and internal wiring.I was fortunate enough to obtain the almost complete circuit diagrams of the VCS3/Synthi A, unfortunately there are so many errors in the drawings, compared with the actual circuit boards, and the internal wiring of the patch panel and front panel potentiometers that I decided to completely re-draw the originals, a very time consuming task, I have also finished the track layouts of the three main PCB's."
via this electro-music.com thread
No comments:
Post a Comment
Note: To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).