"This is a very rare collectible synth. Quite unusual and should reside in a museum or vintage synth collection. Only a few hundred EML200's were made. This unit requires a tube (easily accessed in the rear), and is sold as is. This EML200 synthesizer is vintage. It's a hybrid cross: a synth with cable patches (not included) much like an ARP 2600 or Moog, and a piece of test equipment . The sound possibilities are truly amazing. The tone of this EML200 is very different from that of any other synth made. Vintage 1970s. Even has a built-in spring reverb. More valuable than the silver model. It's a great stand alone unit- or patch your other equipment through it. It looks cool just sitting there! Mic preamp for external sounds. Patch them through the high pass and low pass filters, 3 oscillators, ring modulators. Here's a detailed list:
sine, triangle, square wave outputs (2 each)
noise source (2 outs)
course and fine frequency knobs
-VCO 1
center frequency
2 swing (frequency modulation) knobs
2 swing input jacks
2 outs
-VCO 2
center frequency
2 swing (frequency modulation) knobs
2 swing input jacks
2 outs
-Spring Reverb
input
depth
gain
2 outs
-Switch - you can switch between 2 input signals
A gain
B on time
B gain
ins for A and B
2 outs
pulse input for external clocking
-High Pass Filter
-Low Pass Filter
-Wave Shaper
-Sample and Hold "sampler", in and 2 outs
-Envelope generator
attack, decay, rate, duration
envelope output
carrier and modulator ins
-Modes: manual, auto, ring modulation, amplitude modulation
manual push button
pulse input for external triggering
-Mixers and Pan
6 channel mixer
gain for each channel
2 sets of 3 ins with pan for each set
left, stereo and right outputs (2 each)
-Ring Modulator 2
modulator and carrier ins
gain
2 outs
-Microphone amplifier
2 ins, hi, med and lo outs, gain knob"
No comments:
Post a Comment
Note: To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).