via Noisebug on Ebay"Analogue Solutions Modules are the same physical size and use the same power connectors as Doepfer a100 modules. They will mount in Doepfer eurorack cases and are 100% compatible when patching.
The red stripe on the power ribbon is red line down if used with Doepfer cases.
Included is a eurorack power ribbon and eurorack screws. Analogue Solutions screws available upon request.
Width 18HP
The SY03 is a VC low pass filter and VCA in one module. The VCA is hard-wired in series after the filter output. The filter is a transistor ladder 'Moog' type filter. Resonance can be set to feedback.
Controls In Detail
SIG1 LEVEL
Audio input signal attenuator for the signal coming into the SIG12 socket.
CV1 LEVEL
CV input signal attenuator for the signal coming into the CV1 socket.
CUT OFF
Alters the filter cut-off frequency.
RESONANCE
Alters the filter feedback level.
VCA LEVEL
VCA CV level attenuator for the signal coming into the VCA CV socket. When no jack plug is in that socket, the control is used to attenuate a full CV level (+12v).
Sockets In Detail
SIG1 IN
Signal input to the filter, level affected by SIG1 control.
SIG2 IN
Second input to the filter. There is no level control.
CV1
Cut Off CV input, level affected by CV1 LEVEL.
CV2
Second CV input. There is no level control.
VCA CV
VCA CV level input, level affected by VCA LEVEL control. When no plug is in this socket, the VCA receives a full (+12V) CV level, which can then be attenuated by the VCA LEVEL control."
No comments:
Post a Comment
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).