Sunday, July 18, 2010
Q119 Reset Demo.mov
YouTube via davidryle | July 18, 2010
"I learned this from "simciu".
http://www.youtube.com/watch?v=vCm4yZ...
The idea is to send a control voltage out from any row of the Q119 back into the Start Input of the Q119 sequencer. This will serve to reset the sequencer when one of the steps is turned up.
I also have the Q960 sequencer slaved to the gate output of the Q119 for this demo. The upper sound is controlled from the Q960 and the Bass sound is controlled by the Q119.
The second row of the Q119 is used for rest function of the bass notes.
The same for the third row of the Q960. It is used for the upper notes rest. The ratchet on the upper notes is done with a Q128 switch and the out from a Q963 trigger bus.
Bass is filtered through a Q150 transistor ladder filter at -24dB, and the upper notes are filtered through a Q107 in low pass mode. The CV's for the oscillators are run through a Q171 and Q172 quantizer."
PREVIOUS PAGE
NEXT PAGE
HOME
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).