Click the image for the full size shot. via ersatzplanet on Muff's:"I made a sweet little desktop controller using just Schroff rails and some hand cut plexiglas end panels. Instead of a power bus board I just made a ribbon cable with a bunch of connectors on it. I then made a panel that bused the PS from one of my main cases and also carried over 4 lines to the main case (I used 7-pin DIN connectors). Two of the lines are normalized to the Doepfer CV and Gate buses. A thin Formica panel is slid in the rear grooves and works great. The Tip-top rails can be easily adapted to do the same thing though they are not as deep so panels may have to be made for the exposed edges. I have enough rails left over to make a slanted 6U version next. A cheap source for these rails in the US (at low quantities) is really appreciated. Gur will make a mint off these [see this post]. Especially if he also starts selling a power supply."
http://synthwerks.com/
No comments:
Post a Comment
To reduce spam, comments for posts older than one week are not displayed until approved, usually same day. Do not insult people. For items for sale, do not ask if it is still available. Check the auction link and search for the item. Auctions are from various sellers and expire over time. Posts remain for the pics and historical purposes. This site is meant to be a daily snapshot of some of what was out there in the world of synths.