via Synthwerks"The Synthwerks FSR-2P
Dual Passive Force Sensing Resistor Module
The FSR-2P has two 1.5" square FSR force sensors that are wired directly to two sets of 1/8" jacks. There are no active electronics in the module. The module can pass both audio (AC) and control voltage (DC) signals with output levels proportional to the force applied to the associated pads. With no force applied the FSR appears to the circuit as an 1 Meg resistor (approximately). The Jacks and FSRs are mounted to a 14 HP reversible panel. The panel graphics are so that the panel can be rotated so the user can choose left-handed or Right handed operation.
The FSR-2P is 14HP in width and has a MSRP of $75.(US)"
"The Synthwerks SP-1P Single Passive Slidepot Module
The SP-1P has a single 60mm throw high quality slide pot with its taps wired to a set of 1/8" jacks. There are no active electronics in the module. The module can pass both AC and DC signals with output levels proportional to the position of the slider. The Jacks and slide pot are mounted to a 8 HP reversable panel. The panel graphics are so that the panel can be rotated to choose if the jacks are above (desktop) or below (cabinet) the slide pot.
The SP-1P is 8HP in width and has a MSRP of $75.(US)"
"The Synthwerks FSR-1T Force Sensing Resistor Module with Toggle Switch/GateThe FSR-1T is a single channel FSR module, based on the FSR-1N, but has a large square Force Sensing Resistor sensor that translates the pressure the performer applies to its sensing pads into a user adjustable scaleable control voltage, and an adjustable threshold dependent gate signal. The FSR-1T also adds a section with an electronic bi-directional switch that toggles one input/output between two other inputs/outputs (A & B) or visa versa. This toggle action is driven from the standard gate out from the FSR’s gate out. An internal jumper can choose whether the switch operates in toggle (on-off-on) or momentary modes. The electronic switch is bi-directional and able to pass DC and AC voltages. The IN/OUT jack is normalize to a +V and its output at A & B in toggle mode, will act as a toggling gate at one half the frequency of the standard Gate out. LEDs indicate the active state of all gate outputs.
The FSR-1T is 10HP in width and has a MSRP of $195 (US)"
You can find discussion on Muff's here and here.
No comments:
Post a Comment
To reduce spam, comments for posts older than one week are not displayed until approved, usually same day. Do not insult people. For items for sale, do not ask if it is still available. Check the auction link and search for the item. Auctions are from various sellers and expire over time. Posts remain for the pics and historical purposes. This site is meant to be a daily snapshot of some of what was out there in the world of synths.