via this auctionBlue Lantern on eBay
via the listing: "Here is my new Rev4 DIODE VCF. I also had Pro Panels made. This filter has a 10-stage Diode Ladder. It sounds so sweet! This is the best Diode Ladder VCF so far, and to top it off 6hp!!
These were built by me and are new. I tested each one myself and they are good to go. This auction price is Per Unit Cost. So (1) Diode VCF is $125.00
This is a small run of around 20 units. Get'm while there hot. They will probably go fast so don't wait to long.
Specs:
--------------------------------------------
(1) DIRECT CV Input
(1) FM Bi-polar Attenu-Inverter (+&- CV Input)
(1) FILTER OUTPUT
(1) EACH--HP/LP/BP inputs
There is a trim pot to adjust how much screech you want on the Rez pot. You can make it Squelchy or tame it down.
----I include a 10 PIN to 16 PIN IDC ribbon cable for you to connect to your Euro Compatible Modular Case. I use the Red Stripe is (-12v) standard. Please pay attention when connecting the unit yourself. If connected wrong you will fry the IC chips and see smoke.
The standard is as follows: -12v GND GND GND +12v. On a Doefper system the red strip usually will be on the bottom. On my modules the red stripe is on the top. All I did was rotate the standard connector on my PCB modules.
The panel is made of a High Grade PCB material with White Silk-screening done by a Pro PCB manufacturer. I had to include these costs on this newer unit."
DEMO OF NEW DIODE VCF REV4 by Blue Lantern
No comments:
Post a Comment
Note: To reduce spam, comments for posts older than 7 days are not displayed until approved (usually same day).