via Analog Crafstman
"New! acQA/R: quad attack release EG. A special edition collaboration with hexinverter.net! (Thanks, Stacy) Channels 1and 3 have switch pots for outputting negative voltage. All four gates are normalled to control all four EGs from one gate signal."
Update: demo video added below.
Published on Feb 28, 2013 boothnavy·29 videos
"The new acQA/R quad EG is a special collaboration with hexinverter.net.
Signal path for this demo is:
Modcan 01B VCO - Modcan 67B VCF - Modcan 21B VCA - Synth Tech E580 delay
Because each EG is normalled to channel 1 you can send four separate cv outputs with a single gate event. Channel 1 is controlling cutoff frequency of the VCF. Channel 4 is controlling amplitude modulation.
Channels 1 and 3 have pull switch pots that will output a negative voltage, as is demonstrated at around :30 in the video."
No comments:
Post a Comment
Note: To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).