dtronics NANO series

Published on May 11, 2014 Dtronicsmusic·6 videos

Dudes dancing with guitars.

"The Nano sync converts midi clock to sync pulses.
It has 2 Dinsync outputs that can individualy be set to 24 , 48 or 96 ppqn, and a jack sync output that can be used with arpeggiators or sequencers and it can be programmed from 24/127 ppqn up to 24ppqn.
It has low latency of less than 200 micro seconds.
A Led shows the current clock speed - 1/24 of clock frequency.
Power input: 9 DC, max 100mA. 2.1mm plug, + on center pole

Average latency: less than 0.3ms

****************************************­*****
Nano Merge

Despite its small size and low price, it is an intelligent MIDI merger.
It has two MIDI IN ports and one MIDI OUT port. Both midi inputs are opto-isolated.
An indicator lamp lights when midi data is being received.
The Nano merger handles all MIDI message types, including System Exclusive and MIDI Time Code, and clock.
Channel Voice messages are normally transmitted in the order in which they were received.
Midi timing commands have higer priority.So if Note Data is received at channel 1, and a midi timing message comes in at channel 2, the timing message will be sent to the output as soon as possible, interrupting the note commands from channel 1, ensuring extreme low latency, and minor drift in midi timing.

Power input: 9 DC, max 100mA. 2.1mm plug, + on center pole
Average latency: less than 0.3ms

****************************************­*****

Nano Thru

The Nano Thru is a 1-in 3-out MIDI Thru Box.
The Nano Thru provides additional MIDI Thru ports in a classic MIDI setup.
This way you will eliminate latency caused by daisy-chaining midi equipment.
All MIDI messages appearing at the In Port are sent unchanged to all three Thru ports.
The signal is cleaned by the hardware, by analyzing the data and completing lost data strings ensuring any signal scew is eliminated.
The Nano Thru is externally powered to ensure error free operation over long cables and has a low latency of max. 3 micro seconds.
A MIDI indicator LED flashes when MIDI data is received.

Power input: 9 DC, max 100mA. 2.1mm plug, + on center pole
Average latency: less than 3us"