flickr set by kb_cheapmods
(click for more)
Middle: "CEM3389 Mod Schematic
This shows the CEM3389 datasheet schematic, with 7 of the DIP headers that form part of the socket adapter on the left, and the basic schematic on the right. NOTE: the resistors used were different than I labeled here!"Bottom: "CEM3389 DIP Header Circuit Adapter Sockets
Again the schematic, but with 3 views of the completed socket adapter. Basically, the DIP header has a wire which routes the panning CV over to the resonance pin of the IC - note that I cut the pin off the DIP header that went to the resonance pin, because the Studio440 PCB runs that to ground.
On the IC socket, all pins are soldered to the DIP header EXCEPT for the panning pin, which is lifted out to the right. That is then soldered between two resistors, one that goes to ground and the other that goes to +Vsupply. Esssentially, it's a voltage divider that ties that pin to a fixed voltage right about +2.5V which balances the L-R output of the CEM3389. You can see those resistors configured to the socket adapter in the pic."
No comments:
Post a Comment
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).