Sunday, September 18, 2016
RT-311 Swarm Oscillator: Short Demo Video 1
Published on Sep 17, 2016 Jörg Schaaf
"OK - I have to admit that I had some saturation from time to time at the VCA but beside that, you get a first impression, what you can do with snapshot recalls. After tweaking the knobs a little bit I show the remote control via the data output. So, I am controlling the Cutoff frequency of the RT-451 filter. Then I recall some oscillator snapshots. Beside interpolating between these snapshots they can also be used to recall fixed settings. In this example I synchronised the internal LFO of the swarm oscillator and recall the snapshots with that LFO as presets. Every eight steps it increases the snapshot number by one.
Afterwards I play a cluster, tune the beast up with that cluster, change it to a chord and tine it down again. That video represents only a few of the swarm oscillators features. Our first shipments will be done by the end of october 2016."
PREVIOUS PAGE
NEXT PAGE
HOME
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).