Saturday, August 05, 2017
Pick and Place Electronics Assembly (Neoden 4)
Shifted Phase
Published on Aug 5, 2017
"Here's a complete walk-through of my pick and place setup using the low-cost Neoden 4 pick and place machine from Neodentech. This setup is not fancy or expensive, but is good for small shops building small runs of boards on a regular basis."
Synth manufacturing with Andrew Kilpatrick.
PREVIOUS PAGE
NEXT PAGE
HOME
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).