Published on Sep 19, 2018 MAKEN0ISE
Playlist:
1. Getting Started with René
This video shows how to create and store a two-channel sequence on René. It also briefly demonstrates channel and page navigation, and the basic function of most of the Program Pages. More detail on all these topics will be found in upcoming videos.2. Exploring René
This video shows how to switch between channels and Program Pages on René.3. Cartesian Motion with René
This video demonstrates the core function of René: Cartesian Motion! René uses the X and Y clocks for independent horizontal and vertical motion. It also has a channel dedicated to each of these clocks.4. René Program Pages
This video explores the Program Pages of the René, except for the FUN page, which will be covered in the next video.5. René FUN page
This video explores the FUN Page on René.6. Prism of Composition: Introduction to René's Z Axis
This video introduces the third dimension of René programming: the Z Axis.7. René MESH Programming
Please note: This video is deep. If you’re not already pretty familiar with the Program Pages of René, go watch the earlier videos in the René playlist, use them to make some music, and come back to this one later. You can have endless fun with three channels of X and Y axes before you move onto the Z Axis.
This video is an introduction to programming multiple States at once via MESH.8. René LATCH Page
This video is an introduction to non-destructive sequence editing across States via the Latch pages.
No comments:
Post a Comment
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).