Monday, November 18, 2019
OP-1 - how do i remove usb noise?
Published on Nov 18, 2019 teenageengineering
"sometimes usb noise can be introduced when a usb cable is connected to the OP-1.
to remove usb noise, press and hold shift and the com key. from here, press T4 to reach option mode. turn the blue encoder to toggle usb charging on or off. after a few seconds, this will remove or significantly lower the usb noise.
you can also use a ground loop isolator. connect the line out from OP-1 to the input of your isolator, and from there, connect to your speakers or headphones. this will effectively remove any ground loop noise, while still allowing usb charging to remain on."
2 comments:
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).
PREVIOUS PAGE
NEXT PAGE
HOME
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
Subscribe to:
Post Comments (Atom)
Bad engineering is to blame.
ReplyDeleteGenius!!!!! Thank you you have just saved this instrument for me!
ReplyDeleteNice one