Friday, September 25, 2020
Quick Tip: Fitting A Deep Eurorack Module Into A Shallow Case
Perfect Circuit
"This Quick Tip shows how to fit a eurorack module into a case that is just a little bit too shallow. All you need to do is find out what kind of screws your case uses, M3 is the most common, but some use M2.5 or 4-40. Then you just need to get some standoffs in the correct screw size. Figure out where you want to put the module and put standoffs in the rails where they will line up with the screw holes on the module. Then you just need to tighten down the standoffs into the rails and then screw the module into the standoffs."
https://www.perfectcircuit.com/
PREVIOUS PAGE
NEXT PAGE
HOME
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).