Haken Continuum / EaganMatrix - Four-Note Arpeggiator & Using ContinuuMini with uCVC/CVC

Haken Continuum / EaganMatrix - Creating a Simple Four-Note Arpeggiator - EaganMatrix Programming

"Experimenting today creating a simple four note Arpeggiator in the EaganMatrix. This preset lets you define four tones that are settable in real time using the i, ii, ii and iv controls. Four notes are always played but you could vary that with extra programming. Y induces some octave shifts and a fifth too that you can press with multiple fingers to play the tones polyphonically at the octave - but the tones themselves are not produced by X (but by the controls). Added Speed control and put a couple continuous pedals on two of the controls to change the pitch sequence with your feet. But the real fun comes when you connect a Keith McMillen Softstep 2 and program chord changes - as the Softstep lets you change all four of the i, ii, ii and iv controls together with the press of a foot or hand. I added some balloons as well to summarize the few steps used to create the preset."

Haken Continuum / EaganMatrix - Using ContinuuMini with uCVC/CVC (Control Voltage interfaces)
EaganMatrix Programming

"Discusses how to connect and use a ContinuuMini (also Half/Full and Slim Continuums) with the Haken Audio Continuum Voltage Converter and especially the Evaton Technologies uCVC for playing Monophonic synths and modules (though playing polyphonically will be similar - just use more CVC channels in parallel with preset Polyphony set greater than 1. Here using a Moog Slim Phatty as the instrument being played by CV - but could be any synth or Eurorack or other module that accepts CV inputs. Also introduces EaganMatrix CVC programming that is essential in using CV with non-standard CV interfaces."