Roland Juno-106 Synthesizer Troubleshooting/Repair Quiet Voice

video upload by gstormelectro

"Audio + Video by G-Storm Electro c. 2024

Today I'm investigating an issue with a Roland Juno-106. Voice #4 is a lot quieter than the others. And it's not a calibration issue. 99% certain it is NOT the brand new voice chips I put in as seen in a previous video. Troubleshooting will confirm that statement. So what else could it be? Maybe something EVERY 106 owner will want to be pro-active about mitigating?

This video is posted for general information about my experiences. Always observe safety working on electronics, and never tinker around inside power supplies without first unplugging the power cord. De-soldering components on the Juno-106 must be done VERY CAUTIOUSLY to avoid lifting very tiny delicate traces. If you're not sure about anything, there's no shame in taking your instrument to a qualified service technician.

Timestamps
0:00 Intro & Symptoms
0:35 Voice Chip Swap Test
1:06 Looking at the Wave Chip output
1:56 Waveform Chip replacement
2:23 Testing
2:51 Voice Board inspection and Remedy
3:19 Re-testing, did it work?"

*BLOG* http://gstormelectronica.blogspot.com/
*LISTEN/DOWNLOAD* http://soundcloud.com/gstormelectro