3/11/24 (slower range) ElectroComp EML 200 + Lexicon PCM 70 (1.3 Circular Dlys)

video upload by Cfpp0

"Same patch as in the previous 3/11/24 EML 200 video, but with a lower range setting on the master oscillator:

The ElectroComp EML 200 master oscillator square wave drives the whole wave shaper section and the switch. Sampler is fed one output of VCO 1. VCO 1 and VCO 2 outputs go to the ring modulator. VCO 2 also goes to VCO 1 CV input. Sampler outputs go to VCO 1 and VCO 2 CV inputs. Wave shaper is set to amplitude, with the ring mod output going to carrier in, and modulation input is first getting a sine wave from the master oscillator (until 0:45), then only the switch output is audible until (at 0:53) I change it to the envelope. The ring mod output also goes to the spring reverb, 100% wet, which goes to the switch. The switch output is dry, but a stereo delay from the Lexicon PCM 70 is applied to the output of the wave shaper, which runs through mixer No. 1 on the 200."