Want Clean audio with your Zoom L6 mixer?

Digitakt, Volca Drum and CB Onward: Silent Alchemist Power video upload by myVolts

"Want to hear the silence?
.
At myVolts, we're not just trying to power your gear, we want to give you the best possible audio output too.
.
You may not realise it, but isolation of your power sources keeps your output clean and as you intended.
Everything (including the L6 is powered via USB from the Silent Alchemist).
.
This is a clean feed recorded onto an SD card on the Zoom L6 Mixer.

Note especially between 27 seconds, when the Zoom recording is turned on (pressing the button that turns Red) and 32 Seconds when 'Play' is pressed on the Digitakt. Nice bit of silence right there, no rattle, no hum.

We're all about simplifying your process, with solutions that just work.
.
Setup info 1:
4 X USB Power ports used
1- Digitakt with 12V Step Up.
2-Korg Volca Drum 9V+ Step Up
3-Standard USB-C cable takes 5V and Powers the Zoom L6.
4. Chase Bliss Onward pedal with 9V Negative Step Up.

Audio setup:
Digitakt connected to Zoom L6
Volca Drum output sent through CB onward into Zoom L6.

Note: we would normally give a mixer/recorded it's own independent power source, this is probably the origin of the noise in the mix. However, with the Silent Alchemist, it's not a concern, isolation means no noise, even when sharing a power source.

If you would like to examine these setups,check out PowerMyGear, our free web tool for planning your power setup.
www.myvolts.com/powermygear

The Silent Alchemist is on pre-sale now through our website

www.myvolts.com/thesilentalchemist"