via this auction
Pics and vids captured here.
video upload by kenzie2029August 31, 2010
previously posted "***To skip tech talk, 2:15
As you can see from my blog, this is not my first attempt at bending my Vl-tone. The first time through was OK, but glitchy. For my top panel I used a piece of stainless steel that unfortunately conducted the current from my potentiometers dropping the pitch. Also at the time, the only wire I had was too thick and stiff to work with. So I decided to rip it all apart and start over. This is what I did.
So here are the mods. I used a little help from Casper electronics, he has a mod sheet that gives you a few patch points and three pots. I ended up only using four of the patch points and all three of his pot mods. I also added three extra pots by externally replacing the VLs internal pots. Then I tested and tested and found twelve other patch points that I liked. So that is from the left all the pots and the black RCA jacks.
As for the white RCA jacks, they function as a switch bay triggered by the switches to the right. The smart observer will notice there are nine switches in the array. One turns the bay into a multiple, the top row (on-off-on) engages the bay or sends it to the switches below. Those switches a attached to capacitors and diodes to further change the sound. The pots about the switch array are part of a home made low pass filter with frequency and resonance. Then there is a volume and reset button.
Blog: http://m-england.blogspot.com
Web: http://www.snapshotillusions.com"
No comments:
Post a Comment
Note: To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).