R-60 controlling R-54 - tuneup procedure
YouTube via metasonix | December 25, 2010 | 2 likes, 0 dislikes
"This demonstrates an R-60 MIDI-CV interface tuning itself to control an R-54 set as a VCO.
Those who have problems making an R-60 complete the tuning process could try these suggestions:
1) when setting the initial pitch of the R-54 at the beginning of the tuneup, set the R-54 pitch to below 32 Hz, not precisely at 32 Hz.
2) when tuning is done, press and hold the Learn button, then immediately press the low C key at least 3 times. Then operate the pitch bend while holding the low C key, this clears out the R-60 buffer.
3) if this still does not work, try a hard reset."
Basic voice, R-54 VCO to R-54 VCF, control by R-60
metasonix | December 26, 2010 |
"Simple patch: R-60 controlling one R-54 VCO, feeding another R-54 used as a filter. VCA and EGs are Doepfer. Yes, it really does sound like that. No reverb, delay or other sweetening was used.
If this isn't fat enough, you're pathetic."
PREVIOUS PAGE
NEXT PAGE
HOME
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).