via Burncards where you'll find the full post and more pics. "Applying the chip-bed socket for the actual 3P Upgrade chip assembly is a breeze if your cleanup was thorough. The little guy will pop right into the pre-existing JX3P main board, and with a little solder flux, some soldering skill, permanently affixing the socket is pretty straightforward. One tip not mentioned (because this kit really is for technicians and/or experienced folk) is to match up the little half-circle divot in the chip-bed socket with that printed on the board, which incidentally, matches a similar marking on the chip itself: nothing good comes from installing chips upside-down!"
You can find the KiwiTechnic JX-3P upgrade kit here previously posted here.
No comments:
Post a Comment
Note: To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).