MATRIXSYNTH: Korg Monotribe VCO output mods


Tuesday, August 02, 2011

Korg Monotribe VCO output mods

via Logan Erickson on The MATRIXSYNTH Lounge

"Center lug on the VCA pot is the VCA output... and the 3 positions on the waveform switch are the individual wave outputs. I tested these tonight.. haven't wired them up yet. but they work.. use a 150-1000 ohm resistor on each output."
Posted by matrix at 8/02/2011 08:46:00 PM
LABELS/MORE: , ,

2 comments:

  1. flake014/9/12, 3:59 AM

    isolate synth part for de output mix? this is interesting for effects without affect the drums, like delay.
    thanks!

    ReplyDelete
  2. Anonymous12/16/12, 4:43 AM

    did you finally figure out whag resistor values suited best ?

    ReplyDelete

Note: To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).

PREVIOUS PAGE NEXT PAGE HOME


Switched On Make Synthesizer Evolution Vintage Synthesizers Creating Sound Fundlementals of Synthesizer Programming Kraftwerk

© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
Subscribe to: Post Comments (Atom)