MATRIXSYNTH: Arduino Flex Controller & Arduino Synth


Tuesday, October 11, 2011

Arduino Flex Controller & Arduino Synth


"A controller made to manipulate Pure Data patches using a flex sensor.
The main idea was to control sound via flexion, there are three flex stripes at the center, just using two here, one controls pitch, the other an LFO.
Since it is serial data, you can use this with any other software that allows serial communication.
Copihue"


"Based on the Auduino synth by tinker.it with a few mods.
The code was a little tweeked to get colored noise sounds.
I tried to pull-off a High Pass Filter but I didn't quite get to it in a formal way. Although I was haoppy with the sound.
I added a push button to have a minimum rythm control.
And a switch to change from the more tonal sound to the noise."

1 comment:

  1. i love the flex controller. how did you do that? i have an ideea andyour answer could help a lot!
    thanks. :)

    ReplyDelete

Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).

PREVIOUS PAGE NEXT PAGE HOME



Switched On Make Synthesizer Evolution Vintage Synthesizers Creating Sound Fundlementals of Synthesizer Programming Kraftwerk

© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH