NAMM: AtomoSynth KOE Desktop Mini Modular Set to Ship Feb 1

via this auction
"The Koe desktop is based on the KOE synth voice module and the KONEKO midi to CV module in a laser cut clear acrylic case plus a power source.

Specifications

KOE Specifications
28 HP width, needs +/- 12V power.
One VCO with square and ramp wavefoms with depth and tune controls, tune control is a ten turn potentiometer which allows you easily set octave, tune and fine tune with just one knob.
Noise sourse, it can be set to affect the VCO frequency or it can be mixed with the VCO and audio input.
One LFO with square and triangle waveforms is can be set to affect the VCO frequency or the Filter cut off, it also features an output jack.
High pass and Low pass vactrol based filter with cutoff and resonance/peak control, it also features an input jack to control the cut off frequency.
Two Envelope generators: EG1 with decay control which is set to affect the cut off frequency of the filter and EG2 with attack and release controls, set to affect the volume, it has an output jack and input jack for the incoming gate signal.
Also it features an audio input, it allows process any axternal audio signal with the filter and envelopes.

KONEKO specifications
Midi to CV converter (Volt per Octave).
14HP width,
Power: +/- 12V, +5V .
CV1 PITCH output 0 to +5 Volt range (5 octaves) it comes from a very accurate 12 bit resolution (4096 steps) digital to analog converter DAC, which translates the incoming midi note messages to voltage. It also responds to the pitch bend or pitch wheel control, according to the midi standard it has a range of +/- two half steps.
Glide effect, it affects the CV1 PITCH output.
Gate output 0 or +5 Volt. it has a red LED that indicates when there is an active gate signal.
CV2 output 0 to +5 Volt range, it comes from a 7 bit resolution (128 steps) digital to analog converter, it can be easily set to output the velocity or any controller CC from the midi device.
PROGRAM button allows you easily set the midi channel just by pushing it and then pushing a note in your midi keyboard, the midi channel will be automatically set and stored even when the unit is turn off. It also allows you to set the controller CC for the CV2 output, just push the Program button and move any controller in your midi device and it will be set automatically.
Midi In and Midi Thru connectors, allows you to connect many midi devices in chain.

Built in power source (110V or 220V depending on your country)

Laser cut acrylic case

Included 3 patch cords (30 cm)and 1 audio out cord(1m)

227mm (L), 152mm(W), 159mm(H)"