YouTube Uploaded by iControlMIDI on Jan 28, 2012
"Apple has released iTetra4 v1.2 our Wired and Wireless CoreMIDI iPad Editor for Dave Smith Instruments Tetra.
iTetra4:
• Offers most of the Global parameters and all the Program parameters (Layer A and Layer B) except ‘Push it’ and ‘Assign’ but not the Combo parameters
• Displays some numerical parameter values in semitones, cents, notes, ms, Hz or BPM rather than plain numbers
• Like a hardware step sequencer, displays the used steps lighten up
The Tetra can be edited using the following Pages on iTetra4:
• Page 1: Global parameters and Program Keyboard Mode parameters
• Page 2: Layer A - Program DCO1 and DCO2 parameters
• Page 3: Layer A - Program VCF and VCF Envelop parameters
• Page 4: Layer A - Program VCA and VCA Envelop parameters
• Page 5: Layer A - Program LFO parameters
• Page 6: Layer A - Program Envelop3 parameters
• Page 7: Layer A - Program Modulation Matrix, ARP and Sequencer Modulations parameter
• Page 8: Layer A - Program Velocity, Modulation Wheel, Pressure, Breath Controller and Foot Controller Modulation parameters
• Page 9: Layer A - Program Sequencer 1 and 2 parameters
• Page 10: Layer A - Program Sequencer 3 and 4 parameters
• Page 11: Program Naming
• Page 12: Layer B - Program DCO1 and DCO2 parameters
• Page 13: Layer B - Program VCF and VCF Envelop parameters
• Page 14: Layer B - Program VCA and VCA Envelop parameters
• Page 15: Layer B - Program LFO parameters
• Page 16: Layer B - Program Envelop3 parameters
• Page 17: Layer B - Program Modulation Matrix, ARP and Sequencer Modulations parameters
• Page 18: Layer B - Program Velocity, Modulation Wheel, Pressure, Breath Controller and Foot Controller Modulation parameters
• Page 19: Layer B - Program Sequencer 1 and 2 parameters
• Page 20: Layer B - Program Sequencer 3 and 4 parameters"
iPads on eBay
iPads on Amazon
Does this work with the mopho? I have the imks80 and like it.
ReplyDeleteHi,
ReplyDeleteThanks for purchasing iMKS-80. I am glad you are happy with the product.
RE: Morpho
I did a quick check of the Program Parameters for the Tetra (Tetra_Manual_v.1.3 - Page 52) and Morpho (Mopho_Manual_v.1.2 - Page 35).
It's close but there are couple of differences.
If you can live with them, you can get iTetra4; but as we do not have a Morpho to perform qualification; we cannot guarantee it'll work 100%.
If you are picky, I would recommend not to go for it.
Best regards,
http://www.icontrolmididesign.com/