via this auction
Demos further below.
"Circuit Bent and Modified Roland MC-505 made by GlitchScience
NEW blue LCD installed
Majority of LEDs have been converted to Blue
Circuit Bent with Rotary/Toggle switch LED interface added (more info below)
Functionally appears to be 100% working and was thoroughly, tested using built in diagnosticsPretty good physical condition there are some nicks and scratches
also a small dent in the back right edge of the case
OS v1.07
New 12ft. power cable included
Record button has a Red LED
The beat LED between the 7 segment displays is a Blue/Red LED
Circuit bend interface has two dual Blue/Red LEDs
All other LEDs are Blue
Circuit Bent all Blue LED Roland MC-505 demo
Bend interface consists of 3 rotary switches, 2 toggle (on-off-on) switches, and 2 dual Blue/Red LEDsBends are stable and at worst from testing will cause whine which stops once switched to new bend or bend is turned off via toggle switch
Bend usually work best with single patch.
Many of the bends just cause chaotic 'noise' and may or may not be usable depending on the use
All parameter changes can still be applied to bent sounds, EFX, Cutoff, Resonance, Reverb, Delay, etc.
Bent sounds controllable via MIDI
Warning: rotary switches stop at each end attempting to turn knob past stopping point could damage control interface
Do NOT try to turn past stopping point (resistance can be felt)
How to use bend interface:
Toggle switches are used to turn on bends, rotary switches then turned to change bendsTop toggle switch control
UP position connects TOP rotary switch with Bottom rotary switch blue LED will be lit,
MIDDLE position is off (disconnected)
BOTTOM postion connect TOP rotary switch with MIDDLE rotary switch, red LED will be lit
Bottom toggle switch control
UP position connects MIDDLE rotary switch with TOP rotary switch blue LED will be lit,
MIDDLE position is off (disconnected)
BOTTOM postion connect MIDDLE rotary switch with BOTTOM rotary switch, red LED will be lit"
Circuit Bent all Blue LED Roland MC-505 demo
Published on Dec 25, 2012 glitchscience·3 videos
Circuit Bent Roland MC-505 controlled via MIDI from x0xb0x
No comments:
Post a Comment
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).