New Enclave Flight Cases with Make Noise Power

"The Enclave Flight Cases With Make Noise Power have landed……………….

Enclave Flight 6U Features:

• 104hp
• 2 5/8 Inches / 67mm Depth
• Solid Dovetail Construction – no screws to pull out
• Military Grade two part polyurethane elastomer coating inside and out; Fabric Free (No Tolex to Snag or tear)
• Chevron Black Polymer Corners
• Back Rubber Feet
• Meets all Airplane carry on requirements; only 11 lbs without modules
• Vector Rails with Sliding Nuts. Rails have no slots for losing nuts. Rails are easily removable for adding or removing nuts; 20 nuts per rail and 80 screws
• Carrying handle
• Built In Eye pads for carrying strap
• 12 lbs
• IN STOCK

Make Noise Powered Bus Board for Enclave Flight 6u:

• Power from +15V to +18V DC Wall-Wart, anywhere in the world
• Outputs: 1.4A +12V regulated, 1A -12 regulated, 250mA +5V regulated (there is an option for 1.5A +5V at added cost)
• 24 euro power connectors (2 x 8 male .1" headers)
• Spade connectors for DC IN/ OUT/ GND (for chaining of DC power to multiple boards)
• Spade connectors for +/-12V, System GND, +5V, and the CV/ Gate bus lines (for expansion)
• No heat to dissipate
• Low Noise, high stability
• Conservative Current rating
• Automatic ramp down to shut-off when current draw exceeds 2.2A
• Delayed power up to avoid false blowing of fuses (when powering up several Metasonix modules for example)
• Super-Efficient, averaging 90% efficiency. Much greener then typical linear supplies
• Unique design allow for powering two rows without the need for the passive bus board and additional wiring
• Lightweight and low profile (less than 18mm height)

Enclave Flight 3U Features:

• 104hp
• 2 5/8 Inches / 67mm Depth
• Solid Dovetail Construction – no screws to pull out
• Military Grade two part polyurethane elastomer coating inside and out; Fabric Free (No Tolex to Snag or tear)
• Chevron Black Polymer Corners
• Back Rubber Feet
• Meets all Airplane carry on requirements; only 7 lbs without modules
• Vector Rails with Sliding Nuts. Rails have no slots for losing nuts. Rails are easily removable for adding or removing nuts; 20 nuts per rail and 80 screws
• Carrying handle
• IN STOCK

Power:

• Make Noise Mini-PWR
• Switching power for use anywhere in the world
• Outputs: 800mA +12V regulated, 500mA -12 regulated, 250mA +5V regulated
• 2 euro power connectors for connecting Bus Cables
• No heat, Low Noise and Stable
• Automatic shut-off when current draw exceeds 1.2A
• Lightweight and low profile (less then 18mm height)

We strongly suggest you anticipate your power requirements at www.modulargrid.net. You will quickly see that the Enclave power board is more than adequate for almost all configurations that will fit in a 104hp 3u case."