MATRIXSYNTH: Trogotronic 177M Tube VCA Eurorack Module


Wednesday, June 19, 2013

Trogotronic 177M Tube VCA Eurorack Module

Note: Auction links are affiliate links for which the site may be compensated.

via this auction
Perfect Circuit Audio (RSS)

"Little brother of the double-wide 277 the 177 does in mono what big brother does in stereo. The unique design of the M-series 177 delivers not one but two stages of high-gain (& high voltage) vacuum tube signal path without sonic compromise. Harmonics & Bass-Heavy Compression unique to valve topology are delivered with an economy of “hp” real estate (7.5hp!), meager power supply requirements & cost while maintaining Euro Format CV compatibility.

Yes, “high voltage”—no small task for a euro module. Reason being: even the best euro format power supplies were never intended for providing “B+” (arcane engineer speak denoting High Voltage feed for vacuum tubes). Rather than compromise both the operating specs of the tube & capacity of your modular’s power supply the M Series 277 includes a wall-wart to deliver both High Current & High Voltage to the valves without taxing your rack’s supply. Low voltage / low current circuits patch via included ribbon cable & use only a modest amount of power (see specs for details). 177 provides front & rear jacks for the included supply to facilitate access from outside OR inside your rack (cuts down on added wires getting tangled with patch-cords on the frontside).

Use at the end of a patch: Rich tube harmonics & brawny compressed low-end add warmth to your cold digital effects / signals while reinforcing plastic sounding low voltage analog sound.

Use as overdrive effect: Overdrive effects via CV Drive input is a cinch. Use as external input preamplifier: Gain afforded by the 277 is more than adequate to make even the tiny signal of a guitar or microphone patched straight to the input scream. As a modular synth is more than 1000 times louder you may well wonder what happens when such signal is fed through the 177 with controls all set to “eleven”: brutal distortion!

Features

Warm High Voltage Two-Stage Tube VCA
CV Amplitude Input with Attenuator Knob
CV Drive Input with Attenuator Knob
Ample gain for use as External Input Preamplifier
Zero to +5 volt CV-Range compatible w/most LFOs, Envelopes etc.
Compression with Low-End Enhancement
Warms cold digital effects & low-voltage solid-state signals
Included High-Current Power Supply = low impact on your rack’s “built-in” supply
2 CV Lamps: 1 Blue (Amplitude) / 1 Red (Drive)
Slovakian Max. Gain, Twin-Triode Vacuum Tube run at high-voltage
Small: 7.5 hp x 2.275″ Deep"

No comments:

Post a Comment

To reduce spam, comments for posts older than one week are not displayed until approved, usually same day. Do not insult people. For items for sale, do not ask if it is still available. Check the auction link and search for the item. Auctions are from various sellers and expire over time. Posts remain for the pics and historical purposes. This site is meant to be a daily snapshot of some of what was out there in the world of synths.

PREVIOUS PAGE NEXT PAGE HOME


Patch n Tweak
Switched On Make Synthesizer Evolution Vintage Synthesizers Creating Sound Fundlementals of Synthesizer Programming Kraftwerk

© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH