via this auction

Driven by rapid fire hardware envelope snap, and near Modular sound flexibility (at the flip of any of its 20 toggle switches), the STUDIO ELECTRONICS BOOMSTAR® desktop* synth is a performer and sound designer’s waking dream. The Boomstar foundation: two Oscillators—stackable waveforms with Sub OSC, two Envelopes invertible, loopable, with ‘drone’ and ‘master’ mode, is accented expressively by hardware XMod and exponential glide, extensive modulation routing, and a flexible software LFO: jacked for heavy lifting and fine-tuned experimentation—even go ”off synth” with the external input and color exotic oscillations.
The quick-turn shaft pots along the bottom for the hardware Ring Mod, Noise, Filter Feedback and VCO Levels make vital sonic change intimate, immediate, and indispensable; the adjacent Overdrive switch adds warmth and edge. Thirty one pots insure fluid, intuitive mastery over wide-ranging sweep and subtlety of tone: feather in the changes or whip them suddenly and rhythmically into shape.

Features
All discrete circuity. Hand matched transistors in filter and amplifier.
2 Oscillators: Sub Oscillator, Sync, Pulse Width, Tracking On/Off, Modulation, Fine Tune
Waveforms: Toggle Switches select combinations of Sine, Triangle, Saw and Square waveforms

Filter: Frequency/Resonance Controls, Filter keyboard tracking, Mod depth, Mod Source
2 Envelopes: Attack, Decay, Sustain, and Release controls; Envelope Invert switches, Destination toggle switches
Drone/Envelope 1 Master center-off toggle switch
XMod: Oscillator 2 mod depth to select Osc 1 Pulse Width, Frequency, or Off
LFO: Rate, MIDI Sync On/Off, Waveform selection, Mod Depth, 2 Destinations,
LFO Waveforms: Sine, Triangle, Saw Up, Saw Down, Square, Offset Square 1 and 2, Random, and Slew
Amplifier: 2 Levels of Overdrive, selectable by 3-way toggle
Additional: Master Tune, Glide Time, Dynamics to Filter Frequency, Envelope 1 to Oscillator 1 Pulse Width
Mixer: Osc 1, Osc 2, Ring Mod, Noise, Feedback
Front Panel Jacks: CV In, Gate In, Filter Frequency In, Amplifier In, Oscillator Out, External Signal In
Back Panel Jacks: MIDI In/Out, 1/4" Audio Output, DC Power Out
Back Panel Switches: MIDI Learn Switch (Channel, Note Priority, Aftertouch, Mod Wheel Destination) and Tap Tempo for LFO
Overflow Switch for polyphonic chaining"
No comments:
Post a Comment
Note: To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).