via this action
"This is a great controller for voltage controlled synthesizers and modules.Two ribbon and pressure controllers, switched attenuators, gate OR combiners, 4x 1/8" to banana converts, passive finger touch-point patchbay mixer(!).
I'm not the original owner, and it seems like it was someone's learn to solder project. I've gone and cleaned up the PCB, rewired the ribbon and pressure sensors, and did a general once over. It used to have two LEDs on the underside, which never worked, I've removed them (seems like they were not meant to work -- the voltage they're getting is way too high).
Runs on a +12v DC, 500mA power supply, included with purchase.
specs:
Analog expander / controller designed to fit Ciat Lonbarde instruments. Also can be useful for all Banana modulars.
(2) pressure ribbons with range/offset control (>7v to 0v for position, 0v to >7v for pressure)
(1) 5 => 2 OR combiner
(4) CV knobs (switchable to banana input attenuator)
(5) 2 way switches (2) avdog splitters (16) touch points inputs (4) 1/8 to banana (1) ground all 3-way switches so you can turn off the signal slim profile satin finished stainless steel faceplate acrylic box size : 530 * 165 * 23.6 (not including screw head and knob) (mm)"
No comments:
Post a Comment
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).