MATRIXSYNTH: Sequential Circuits Prophet-10 Synthesizer With Sequencer and Braemer Drive

Thursday, October 13, 2016

Sequential Circuits Prophet-10 Synthesizer With Sequencer and Braemer Drive

Sequential Circuits Prophet-10 Synthesizer for sale 10/12/2016 - Located in Alaska, Will Ship

Published on Oct 12, 2016 13angryBs

"For Sale, Sequential Circuits Prophet-10 Synthesizer.
Located in Anchorage Alaska, I will ship UPS Air Freight"

via this auction

Video and some new pics for the Prophet-10 previously posted here.

Note what appears to be a serial number on the little cassette tape: 1612-5785.

Pics of the inside below.

Some details added to the new listing:

"Update, 10/9/2016 - I have just ordered a replacement potentiometer from wine country, and It will be included with the sale. You can replace the potentiometer or just the nylon post,
but it will require removeing the potentiometer from the PC board either way.

Update 10/8/16 - Attention: the post and knob are broken off potentiometer for the Pulse Width on Oscillator B. - It happened last night when I accidentally dropped my huge headphones on the top deck. [photo below]

Update: 10/6/16 - This Prophet 10 works, but has a few issues,
So it will need a trip to a Synth Tech.

I just ran the Diagnostic ROM and Loaded the factory presets. The Diagnostic was completed and showed No Errors. - But there is something strange going on with this thing,.. In General all notes work when you first turn it on, but after it warms up for 20 minutes, some notes will go out of tune and some notes will stop working. If you turn it off for a while and check again, the notes will be working. It seems like it's Voice 6 and Voice 9 on the lower board that are the ones cutting out. And the ones going out of Tune seem to be on the upper keyboard when it's in single mode, The notes are in tune when in Double mode. - I previously mentioned there were notes that were clicking, but later realized that was only because I had the sustain turned down way too far. So that's not an issue
Everything else seems to work fine as far as I can tell.

I have changed the Condition to "For Parts or Not Working" - To protect myself from any issues relating to ebays Buyer Protection policy. Because the "Used" condition description states the item is fully functioning. When my item is technically not fully functioning. It does need minor work. I am Selling this As-Is with no returns.
So Please Read The Full Description..."

No comments:

Post a Comment


©2018 Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.