Tuesday, May 29, 2018
Eurorack delayed envelope VSL D-ENV self-cycling looping feature demo
Published on May 29, 2018 Vintage Synthlab
1. Jump the GATE IN jack and D-G IN jack with a stackable.
2. Set the DELAY to maximum, and the HOLD to about 50%.
3. Use another cable plugged into the jumper at the D-G IN jack and momentarily connect to the INV OUT jack (this takes advantage of the INV OUT's resting or nominal +8V for a positive trigger feed into the D-G IN jack which in turn feeds the DELAY timer a signal to start the timing process.
4. In less than one second after initially connecting the INV OUT to the trigger cable, move it over to the D-G OUT jack before the HOLD L.E.D. goes out. If you connect before then, you should have a self-cycling D-ENV!
The above procedure is safe to perform on the D-ENV module. Any deviation from this method, including different voltages, different systems, or modifications are not recommended by VSL.
PREVIOUS PAGE
NEXT PAGE
HOME
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).