via this auction
"Plug in for SCSI port which expands the internal memory (four times original memory) of the original EPS sampling keyboard/workstation (13 bit). With this expander, this allows as much 167 seconds of sample time the RAM."
Sunday, January 12, 2020
Ensoniq EPS 4X-Memory Expander (Model ME-2)
Note: Auction links are affiliate links for which the site may be compensated.
via this auction
"Plug in for SCSI port which expands the internal memory (four times original memory) of the original EPS sampling keyboard/workstation (13 bit). With this expander, this allows as much 167 seconds of sample time the RAM."
via this auction
"Plug in for SCSI port which expands the internal memory (four times original memory) of the original EPS sampling keyboard/workstation (13 bit). With this expander, this allows as much 167 seconds of sample time the RAM."
1 comment:
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).
PREVIOUS PAGE
NEXT PAGE
HOME
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
Subscribe to:
Post Comments (Atom)
Hello,
ReplyDeleteI've recently acquired an Ensoniq EPS and it has this ME-2 expander in it. However, there is a very small wire that has come loose that appears as though it was soldered to the second "pin" connector from the end. I can't find any photos of this expansion board with the cover removed. If you still have this item, is there any way you might be able to remove the four screws on the main body and lift the lid off and shoot a picture for me of the surface of the circuit board? You don't need to remove the two screws on the bottom under the label. This would be a HUGE help if you can. Your 4th picture that shows the connector strip is the view I'm looking for. Thanks!