via this auction

The inputs (microphone) are optionally a 6.3 mm jack and an XLR port. A level controller regulates that pre-amplified signal and a green and red LED provide information about the clipping status.
For the carrier, there are two inputs that can be used in parallel. The level can be adjusted from -30 dB, -15dB to 0dB with a three-way switch. There is also a guitar input, which can also be used for instruments with big dynamics. That’s possible, because of the Compressor located just behind the input.
In addition, the signal can still be adjusted via the harmonics potentiometer enriched with overtones and slightly distorted sounds. The frequency section below controls the volumes of the eleven filter bands. In addition, there is a Master volume and and a balance control in order to adjust the ratio between the original input signal and the vocoder sound."
No comments:
Post a Comment
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).