via SYNTH CITY Reverb
Note auction links are affiliate links. See the site's privacy policy for more info.

-Replaced ALL electrolytic caps
-Disassembled and cleaned all faders/lubricated
-Cleaned all switches
-Cleaned all pots
-Resoldered female end of connectors (pcb side)
-Cleaned all pins on connectors (wire side)
-Removed and cleaned buss bar
-Cleaned all the keybeds j-wires
-Cleaned all calibration pots
-Replaced faulty operational amplifier IC and transistor in noise generator
-Rewired right hand side cabling harness between upper and lower sections
-Cleaned panel and knobs
-Cleaned key bed assembly and lower panel
-Tuned and calibrated the entire synthesizer according to specs in service manual
-Reseated rubber gromets on front panel
-Burn-in and bench tested for several hours"
No comments:
Post a Comment
Note: To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).