Casio CZ Synth PROGRAMMING

video uploads by Scifi Funk

Follow-up to this series below.

"How to really understand programming the Casio CZ Series from the CZ-101 to the CZ-1
https://hyperfollow.com/scififunk/

This series demonstrates how the synth works at a detailed level. By the time you have watched them all, you will have a great idea of how all the parameters interact for making sounds.

The Casio CZ-101 was my very first poly synth bought way back in 1985."

Playlist:

Casio CZ Synth PROGRAMMING. 1 of 4. “Creating movement”. (CZ 101, CZ 1000, CZ 5000, CZ 1 etc)

00:00 CZ-101, CZ-1 Introduction to programming using the Virtual CZ plugin.
00:40 We start with most basic sound BUT with Velocity sensitivity, so the sound is alive as you play (tone movement).
01:51 Fine tuning movement. The built-in chorus, plus Chorus defined (technically).
02:56 More fine tuning movement. A manual chorus - using the Vibrato section.
03:41 Harmonic movement. Using a chord that doesn’t resolve. E.g. C Maj 7 flat 5.
04:22 Add a vintage reverb with a long tail and the sound comes alive.
05:17 Using Detune to add movement. Line 1 + Line 1 or Line 1 + Line 2.
07:25 Future lessons will use the Envelopes to add further movement.

Casio CZ Synth PROGRAMMING. 2 of 4. “Combining Waveforms”. (CZ 101, CZ 1000, CZ 5000, CZ 1)

00:00 Combining Sawtooth and Square Waves (keeping the same octave discussion)
01:00 Combining Sawtooth with the other waveforms inc. Resonance waveforms.
01:51 How resonance waveforms can work the same as a resonance slider.
04:11 Using resonance to sound a bit like a vocal sound (low-end frequencies).
06:01 54% is the magic number for performance vibrato (demo as well)
06:25 Stacking. Super Saw wave examples.
07:29 Ring modulation add complexity (or fuzziness) to a sound.

Casio CZ Synth PROGRAMMING. 3 of 4. “2 Osc FULL CONTROL”. (CZ 101, CZ 1000, CZ 5000, CZ 1)

00:00 How to have full control over 2 oscillators. Set up explained.
02:16 Start point. A tiny delay means it sounds like its being phased/flanged.
03:19 Lets hear how each combination of waveforms sound.
04:00 The threshold for hearing the same waveform on the other oscillator.
04:50 Using envelopes to smooth filter sweeps.
05:35 More combinations.
06:39 Pulse width discussion. Using Filter sweeps to hear the differences in waveforms)

Casio CZ Synth PROGRAMMING. 4 of 4. “4 Osc STACKING”. (CZ 101, CZ 1000, CZ 5000, CZ 1 etc)

00:00 How to have full control over 2 oscillators. Set up explained.
02:16 Start point. A tiny delay means it sounds like its being phased/flanged.
03:19 Lets hear how each combination of waveforms sound.
04:00 The threshold for hearing the same waveform on the other oscillator.
04:50 Using envelopes to smooth filter sweeps.
05:35 More combinations.
06:39 Pulse width discussion. Using Filter sweeps to hear the differences in waveforms)