IM TZ Dual VCO demos

video upload by Todd Barton

"This and other great modules are available at https://www.infinitemachinery.com/

Also, there will be a booth at Knobcon next month https://www.knobcon.com/"

"The TZ Dual VCO is two full featured VCOs on in a single 16HP module. Both VCOs output sine, square, saw, triangle and PWM wave forms. Each VCO also has thru-zero and expotential FM input. The type of FM is selectable using a toggle switch. An important feature of TZ Dual VCO is the FM input for each VCO can be control by a VCA input. A potentiometer adjusts the overall maximum of the FM input while the VCA provides an amplitude envelope.

Each VCO has the following inputs:

1V/Oct
PWM CV
FM signal
FM signal VCA
Each VCO has the following wave form outputs:

Sine
Square
Saw
Triangle
PWM
Each VCO has these adjustment knobs:

Coarse
Fine
PWM
FM amount
The upper VCO can be synced with the square wave of the lower VCO. A three position toggle switch is used to select hard sync (up), soft sync (down), or no sync (center).

Current requirements - 130mA +12V, 130mA -12V"