MEMS Prototype Of The Buchla Location Voltage Processor

video upload by Source Of Uncertainty

"The 223 Location Voltage Processor is intended to be used with the 227 System Interface Module in a quad setup. It contains four separate voltage controlled processors that output an X and a Y voltage for the 227 assign inputs. The top row of knobs defines the operating range by adjusting the baseline of operation. The Balance adjusts the left to right panning. The Cross-Pan controls row modifies both the X and Y outputs and the exact function changes with the setting of the Balance control. These controls are described in more detail under Operations below."

see here

https://www.memsproject.info/

Psychedelic Tabla Buchla Jam 02 24 2026

video upload by djangosfire

Modules used in this patch:
Soundfreak Triple Oscillator
MEMS: 266, 292c
Mike Peake Custom 190 Dual Reverb
EMS: 277, 207, 281, 256, 257, 246
Source of Uncertainty 219
Recorded live - Cheers to music and sonic exploration! Thank you, Adam Scramstad

Buchla - MEMS 264 Sequence Distribution For Quad

video upload by DARK SPARKLER

"The MEMS 264 quad sample and hold / polyphonic adaptor distributes a set of quantized notes randomly from the MARF to 4 oscillators. These oscillators are each hard panned to the 4 corners of the room through the 227e. The Nensen Electronics Programmable Pulse Matrix sends probability based pulses to the 264 and the 4 channels of the 281. 4 random voltages feed into the decay inputs on the 281 channels to vary the length of each percussive “hit.” A CV processor, mixed with random and a pulse output from the MARF brings in and out the 277 delay, that also has its delay time randomly bouncing between 2 different settings. The oscillator’s wave shapes are introduced half way through to give 2 saw waves and 2 square waves. Cross frequency modulation between the 4 oscillators randomly turn on and off later into the patch."

MEMS 296 Parsed Beat

video upload by Todd Barton

"Sound source is the Soundfreak EMS Triple Oscillator gated and going to the MEMS 296 Spectral Processor where different bandwidths of the fundamental sequence are parsed out and brought into the mix either the Buchla 207 mixer.

Soundfreak https://www.soundfreak.io
MEMS https://www.memsproject.info
Buchla https://buchla.com"