Title link takes you to shots pulled via this auction.Details:
"EMS Synthi Clone in Doepfer Case with Analog Systems modules
-1x Doepfer Koffer
-20 x 20 Ghielmetti Matrix
-22x Pins (2,7 kOhm) like the EMS white Pins.
Analog Systems Modules:
-1x RS95e: The new RS95e VCO is identical to the RS95 but has a fine tuning frequency control.
-1x RS500e: Genuine Ems synthi filter. This legendary filter can be switched between pre1974 and post 1974 filter type and response. For the first time response can be voltage controlled which was designed on the circuit board but not available on the matrix. This module is made under license from EMS.
-1x RS510e: Genuine Ems trapezoid generator featuring Attack, On, Decay, Off and Trapezoid output level. With v.c of Decay time, status led, Sig in and Sig out, Gate in and Outputs A and B this classic timing generator when used with Rs500e captures the essence of the VCS3 and Synthi A. This module is made under license from EMS.
-1x RS220: Joystick. High quality unit.
-1x RS380: Modulation controller useful for Sorcerer and Leviathan systems. VC-LFO, Noise, Random Generator and VCA!"
Well getting that matrix made into a Eurorack is definitely quite interesting. Though looking at the details you can see they had two tries with screw holes on the matrix and didn't get the width right. Note all the gaps on the bottom row.
ReplyDeleteFWIW. The not included ASys ring mod module seems to be based on the EMS too. One could add a spring module too.
the screw holes might be the common fudge for the incompatibility between doepfer and AS racks. the hole spacing is different. so some just make a wide hole that spans both. these euro systems have incompatibility quirks, especially with lots of others jumping on the bandwagon (plan b, livewire, bananalogue, cynthia, etc.)
ReplyDeleteThat may have been the intent, looking again and seeing what seems to be the same thing at the top... though it didn't work as the module isn't lining up any better
ReplyDelete