Create Benny Benassi's Bring The Noise (Pumpkin) Synth In Reason 4.0!

YouTube via luckydatevideos
"Instructions for this video:

Take the "Yeah Yeah" synth and on the second oscelator change the semi from 4 to 7.
Next add a RV-7 Digital Reverb and choose the large hall setting set the dry/wet to 12
Create a Mclass Compressor and set the threshold all the way to the left, the ratio all the way to the right, the attack all the way to the left, and the release all the way to the right.
select the "soft knee" button"

Create the "Yeah Yeah" Bodyrox synth in Reason 4.0! (Tutorial)

"Instructions for "Yeah Yeah" Synth:

First create a Thor synthesizer
Set the polyphony to 4
And the release polyphony to 1
Now select mono retrig under keyboard modes
Select on for the portamento
Now click show programmer so we can actually get this synth rolling
In the first oscillator leave it as an analog and move the octave to 3
Now turn the little knob below tune and make sure its a t OSC 1 PW 64
On Oscillator 2 add another Analog Oscillator, the octave should be set at 4 and the semi should be set at 4
Set the tune knob to 11
Once again turn the knob under tune and set it to OSC 2 PW 64
Now add a third Analog oscillator.
The octave will be 2
This time switch the type of synth from the downhill line to the squiggly one
And turn the knob under tune to OSC 3 PW 64
On your low pass Ladder Filter make sure 123 are selected
Now lets move over to the filter envelope
Set a to 1.9 d to 349 s to -48.2 and R to 705
On the amp envelope set a to 1.2 d to 349 s to 0 and r to 1.09
Now we are going to make the sound change for your modulation wheel, for source go to performance and click mod wheel, set the amount to 64, and for destination go to filter 1 filter frequency
Now add a BV512 Vocader switch the fft knob to 4 band and switch the knob from vocader to equalizer
Switch the decay to 127
Move the shift to -30
move the hf emph to o and the dry wet to 127
Now create a RV7000 Advanced Reverb and select all warm plate
Now enable the eq
Set the decay to 0 the HF damp to 25 the hi eq to -4 and the dry wet to 18
Now create an mclass equalizer and selct the 30 hz lo cut button
On the lo shelf set the frequency to 106.2 and the gain to 1.7
Now select the button on param 1 and set the frequency to 114.9
The gain to 4.6 and the q to 4.9
Next create a mclass maximizer and set the input gain to 6
Select the 4ms look ahead button
Set the second fast button to auto
And switch the peak button to vu"